News

To build To build Remote Controls

Building a remote control might be an exciting strategy to find out about basic electrical components. A simple remote control uses infrared signals to inform a receiver box to do something. Essentially the most basic remote controls merely turn a machine on or off. The components needed might be located at most hobby shops or electronics outlets specializing in individual parts. Premade remote control boxes are the popular approach to house the components, as they offer more ergonomic and traditional designs. Knowledge of not only the structure of the remote control but additionally how it can be used to manage a receiver is imperative when constructing this device.

Things You will Need
Remote control housing
Push button switch
Battery holder
3 volt battery
Copper wiring
NPN silicon transistor
Meg 1/4W resistor
22K 1/4W resistor
PNP silicon transistor
Infrared LED
C220.01uF 16v ceramic disk capacitor

Place a push button switch into the side of the remote control housing. Fasten a battery holder to the upper right corner of the housing.

Attach a wire to the negative terminal of the 3 volt battery holder and run it to the push button switch. Run a wire from the push button switch to the NPN silicon transistor and to the Meg 1/4W resistor. From the Meg 1/4W resistor run another wire to the 22K 1/4W resistor and to the PNP silicon transistor.

Place the infrared LED into the front of the remote control housing. Run wires from both transistors to the infrared LED. Run a wire from the 22K 1/4W resistor to the C220.01uF 16v ceramic disk capacitor. Connect the ceramic disk capacitor to the NPN silicon transistor.

Run a wire from the PNP silicon transistor to the positive terminal of the three volt battery holder. This may close the circuit and allow the present to flow. Be sure that the push button switch is within the off position and place a 3 volt battery into the battery holder.

Point the LED of the remote control at a receiver and it should power on and off. If the receiver doesn’t respond, hold down the push button switch and point the LED at the receiver. Adjust the taper or pot within the receiver until you hear a click. The remote control and the receiver needs to be linked.

Tips & Warnings
A high output LED can be utilized so as to add additional range to the remote control. Bright light will impact the accuracy of the link between the LED and receiver.
To avoid shock, make sure to add the battery at the top of the construction process.
Related Searches

Photo Credit nlitement (still) / Ravedave (animated)
Promoted By Zergnet

Be the First to comment.

Leave a Comment

Your email address will not be published. Required fields are marked *