Doorbell Button Is Stuck

A stuck doorbell button will prevent it from functioning properly. The button is probably going worn out from use and weather exposure. Regardless that it is wired electrically, it’s a project that the average homeowner can accomplish. The voltage is low and therefore does not even require shutting the power off. It is important to repair your broken doorbell in order that you will know when visitors and deliveries arrive at your door. A doorbell is an important part of your private home’s exterior and ought to be maintained at all times.

Things You may Need
Replacement doorbell button assembly

Unscrew the doorbell screws that go through the doorbell button assembly into the exterior of your house with a screwdriver.

Lift the doorbell button assembly off of the exterior of your home. Sometimes, layers of paint may cause it to stay, so you might have to exert some pressure until the paint seal is broken.

Remove the screws on the backside of the doorbell button assembly that hold the two wires in place. Remove the wires from around the screws. They’re very low-voltage, so you shouldn’t have to worry about electric shock.

Hold the replacement doorbell button assembly near the exterior of the house where it is going to be installed. Connect the wires in place around the screws on the back side of the replacement unit. Tighten the screws with a screwdriver.

Position the replacement doorbell button assembly in place on the exterior of your property. Drive the provided screws through the mounting holes in the assembly into the exterior of your home to secure it in place.

Tips & Warnings
Keep your doorbell button assembly in an area of your exterior that’s covered so that it will likely be protected from harsh weather that will cause it to wear and stick.
Wear eye protection when using a screwdriver.
Related Searches
This Old House: How to repair a Doorbell
Popular Mechanics: 6 Low-Voltage Electrical Repairs You can do Yourself

Be the First to comment.

Leave a Comment

Your email address will not be published. Required fields are marked *